A good used lower unit for a 3 cylinder Mercury, Mariner or Yamaha 2 stroke Long shaft outboard engine. It was tested before removal, it could use a...
A transom clamp for a 2.5hp Mariner outboard engine. The screws are in good condition, not seized. It could use a rub down and repaint as some of the...
A good recoil starter assembly for a Mariner 6hp 4 stroke outboard engine.
A very good used Mariner straight 6 90hp engine block complete with flywheel. It is just the block, crank, pistons, reed block, as shown. It does not...
A complete middle section for a Mariner 90hp straight 6 tower of power outboard. The trim / tilt works perfectly, it is in good overall condition and...
An ignition coil for single cylinder Mariner engines, this one was taken from a 6hp 4 stroke model but it was fitted to numerous Mariner and Yamaha...
Complete rear panel with tilt trim and choke solenoids, as shown. Came from a 90hp tower of power.
A control cable retainer for Mercury and Mariner engines dating from the mid 1989's, the all important part number is 39536, also sometimes 87609.
A pair of carburettors for a Mariner 50hp 3 cylinder 2 stroke outboard engine. They were taken from a working engine but will need a good clean...
A plastic Engine cover for a mid 1980's Mariner 2 stroke outboard engine. It has a few scratches but no breaks or cracks.