An ignition coil for single cylinder Mariner engines, this one was taken from a 6hp 4 stroke model but it was fitted to numerous Mariner and Yamaha...
Complete rear panel with tilt trim and choke solenoids, as shown. Came from a 90hp tower of power.
A control cable retainer for Mercury and Mariner engines dating from the mid 1989's, the all important part number is 39536, also sometimes 87609.
A very lightly used starter motor for Mercury and Mariner straight 6 2 stroke outboard engines. These were used on the tower of power models and some...
A pair of carburettors for a Mariner 50hp 3 cylinder 2 stroke outboard engine. They were taken from a working engine but will need a good clean...
A plastic Engine cover for a mid 1980's Mariner 2 stroke outboard engine. It has a few scratches but no breaks or cracks.
A propeller for a Mariner 6hp 4 stroke outboard circa 2000, it is an aluminium 3 blade unit, it has a couple of tiny nicks but is in perfectly usable...
A propeller for a Mariner 2.5hp 2 stroke outboard engine. It is in very good condition with no chips or cracks. It is of the pin drive design and may...
A very good set of genuine Quicksilver controls for Mercury / Mariner outboard engines. The controls have tilt and trim switch, throttle only...
A decent gearbox for a Mercury or Mariner tower of power straight 6 90hp outboard engine - it fits others too. Please note this is a 2.3 to 1 gear...